pil auf opensuse installieren
Verfasst: Samstag 15. Oktober 2005, 13:02
ich will mir pil installieren .
-----------------------------------
$ gunzip Imaging-1.1.5.tar.gz
$ tar xvf Imaging-1.1.5.tar
$ cd Imaging-1.1.5
$ python setup.py install
----------------------
leider kommt
_imaging.c:2810: error: redefinition of ‘PyTypeObject ImagingDraw_Type’
_imaging.c:148: error: ‘PyTypeObject ImagingDraw_Type’ previously declared here
error: command 'c++' failed with exit status 1
habe das gleiche problem mit soya
was muss ich da bei python umstellen damit das funktioniert
mfg
gerhard rogen
-----------------------------------
$ gunzip Imaging-1.1.5.tar.gz
$ tar xvf Imaging-1.1.5.tar
$ cd Imaging-1.1.5
$ python setup.py install
----------------------
leider kommt
_imaging.c:2810: error: redefinition of ‘PyTypeObject ImagingDraw_Type’
_imaging.c:148: error: ‘PyTypeObject ImagingDraw_Type’ previously declared here
error: command 'c++' failed with exit status 1
habe das gleiche problem mit soya
was muss ich da bei python umstellen damit das funktioniert
mfg
gerhard rogen